The term “site area” refers to the area of a site, which includes the footprint of a building. It is also known as the property area, and it encompasses all areas of a property. It is the limit of work that can be done. If the entire property has to be redone, it will take a significant amount of time. The process is best handled by a professional engineer who understands the area well and can properly calculate the net acreage.
This measurement is taken from the outside of the party wall and is inclusive of all roofed areas. A building’s net floor space (NFA) is the total floor space of the building. This area includes the width of the party wall and all other exterior walls. A site’s minimum square footage is 1,000 square metres, which is the same as the size of a typical flat.
The floor area ratio of a building is the ratio between the gross floor area and the total site area. A 10,000-square-foot building occupies a 20,000-square-foot land, while a 2,000-square-foot building occupies a similar sized plot, it is only ten percent of the land. If the site area is 2,000 square meters, a building will have the same floor area as a home.
In addition to the floor area, the FAR is a measure of the development intensity.
A building’s FAR is the ratio of the total gross floor area of a building to the total site area. An FAR of 0.50 means that there is one square-foot of building space for every two square-foot of land area. A 2,000-square-foot building would have a FAR of 0.1, which is the same as a building of ten square feet. In other words, a high FAR means that a building with a FAR of ten means that it would be 10% of the whole site.
The site area for a building is its gross floor area and the building’s total floor area is known as the gross floor area (GFA). This refers to the floor space of the building as seen from the sky. It is the minimum size required for a building. A condominium requires a larger site area because it includes communal and recreational facilities. It also requires the adjoining lots to be suitable for redevelopment as flats. Such sites are known as “left-behind” lots. In addition, they must meet the minimum 1,000-sq-m requirements to be redeveloped into flats.
The gross floor area of a building is its total floor space as seen from the sky. The building’s BCR is restricted between 30% and 80%, depending on the Land Use Zone category and the type of building. If a site has a 50% BCR, a building must not exceed 50m2. This is the maximum allowed for a building on a land area of 100 square meters. In order to avoid overbuilding, it must be built within the BCR of the zone.
It is the ratio of the gross building floor area to the total site area.
A ten-square-foot building would have a FAR of 0.50, meaning there is one square foot of building for every two square-foot of land area. However, a two-square-foot structure would have a FAR of only a thousand square feet, which is one-tenth of the entire site’s surface.
The floor area of a building is the highest horizontal surface of the building. It is equal to the outer surface of the exterior walls. A site’s FAR is measured in terms of the number of square feet per square foot of the building. A building with an FAR of 0.50 would be equivalent to 50% of the land. 사업자아파트담보대출 A one-square-foot building would have a FAR of 0.10. The difference is that a ten-square-foot building would require a site area of 2,000 square feet.
Building square footage is the maximum area of a building on the exterior surface of its walls. Common areas are the areas outside of the building and within the perimeter line of the Project. These include roadways, parking areas, loading and unloading areas, and enclosed patios. If these are not used, they are not included in the total area of the building. If they are located outside of the building, then the building area would be smaller than the total area of the property.